Installation
The covering is fixed with dispersion adhesive. Please turn to the adhesive manufacturer if you have any questions about the adhesives.
The lengths of the covering are glued in a tight butt joint. Butt joints are welded with a welding rod. Also overlapping (2-4 cm) seams can be used. Overlapping is secured with a suitable cold welding fluid. A pencil cove should be done on outer corners to secure the installation. Installation temperature should be over +18 °C.
MAINTENANCE
Initial cleaning
Wash with alkaline detergent solution. Do not use abrasive cleaning implements. Dry the surface carefully after washing.
Initial polishing
Initial polishing is not necessary.
Daily maintenance
Damp or wet clean with a mild alkaline detergent solution, depending on type of soiling. The use of care maintenance agents also recommended.
Stain removal
All stains must be removed immediately to avoid permanent marks.
Warning
Stain remover may affect the covering or the adhesive. When in doubt about the effect of stain remover carry out a test or contact the product manufacturer.